How Fast White Teeth Whitening System Works

Repeat this process once per day for five days.

1: Ready...

Begin by forming your mouth tray - instructions here . Brush teeth
with Fast White Pre Whitening toothpaste and rinse your teeth before each teeth whitening application. This will ensure maximum teeth whitening action while wearing your customized trays.

2: Aim...

Place a small bead of teeth whitening gel in the lower-frontal portion of the Sure-Fit whitening tray. Avoid overfilling trays with teeth whitening gel, a small amount will deliver maximum whitening power.

3: Whiten!

Carefully place gel-filled upper and lower teeth whitening trays over teeth, and close mouth. Avoid swallowing excess gel. Remove teeth whitening trays after 60 minutes. Brush or rinse remaining teeth whitening gel away from teeth and gums. Do not wear while sleeping! Clean teeth whitening trays with a toothbrush and cool water. Store trays in an anti-bacterial case which is provided.

It takes days not weeks to have a brighter, whiter smile with Fast White.

The Sure-Fit Teeth Whitening Trays

The Sure-Fit teeth whitening trays will conform to the contours of your teeth and are almost unnoticeable when worn. Follow the step-by-step process to create mouth trays that will be a Sure-Fit for you.

Step 1 :: Heat water just below boiling point in
on high in the microwave for approximately 1-1 ½ minutes, depending on microwave wattage, container size and amount of water used. (Water temperature should be approximately 160 degrees.)

Step 2 :: Insert the teeth whitening trays into the water so the arches are completely submerged.

Step 3 :: Slowly wave the teeth whitening trays in the water while holding the tab until the tab becomes flexible. A slight loss of shape will be noticed in the trays.

Step 4 :: Lift the teeth whitening trays vertically from the water and test for flexibility. The tray material should be soft and pliable.

Step 5 :: Use your finger to slightly flatten and flare the front segment of the tray and then spread the tray to avoid it from folding on itself. Widen the teeth bleaching tray enough to accommodate fitting.

Step 6 :: Place teeth bleaching trays over upper teeth first. Use tab to approximate center. Bite down with moderate pressure to set trays in place.

Step 7 :: Press firmly over entire length of arch with first finger and thumb of both hands. The tray is conformed to the surfaces of the teeth when heat is no longer felt, approximately 15-30 seconds.

Step 8 :: Close lips and bite lightly a few times prior to removing the teeth bleaching trays.

Step 9 :: Allow teeth whitening trays to completely cool outside of the mouth.

Step 10 :: Place teeth bleaching trays in mouth and evaluate fit. Whitening trays should have precise but not overly tight fit. Rough edges or pressure points may be relieved by trimming with scissors and/or re-warming trays.

Step 11 :: When the edges of the trays are smooth, re-warm the entire tray a few seconds and insert one last time to relieve tightness. Put teeth whitening tray on and off teeth to insure there are no significant undercuts, and the removal is smooth with a slight
retention.

Step 12 :: After using teeth whitening gel, rinse trays with cool water and store in the anti-bacterial case included in the kit.

CAUTION :: Once the tray enters the heated water it becomes extremely flexible. Be careful not to allow the edges of the tray to fold onto itself. Repeat procedure if the tray is not soft enough to form to your teeth, or if you are not satisfied with the fit.